LED traffic light module compatible with Arduino

4.9 (533) · € 1.99 · In Magazzino

One LED traffic light module, which is compatible with Arduino, is a module that contains a set of red, yellow and green LEDs that simulate a traffic light. The module usually consists of three LEDs (red, yellow and green), each connected to a separate digital output pin on the microcontroller. The module also contains a circuit board with built-in resistors and other necessary components to connect the LEDs to a microcontroller. This module can be controlled by a microcontroller via digital output pins. It can be used to create a traffic light simulation or as a visual display in projects such as traffic management systems, intelligent transportation systems, or other projects where traffic light simulation is required. The module can be programmed to switch traffic lights according to a specific pattern or in response to specific inputs such as sensors
One LED traffic light module, which is compatible with Arduino, is a module that contains a set of red, yellow and green LEDs that simulate a traffic light. The module usually consists of three LEDs (red, yellow and green), each connected to a separate digital output pin on the microcontroller. The module also contains a circuit board with built-in resistors and other necessary components to connect the LEDs to a microcontroller. This module can be controlled by a microcontroller via digital output pins. It can be used to create a traffic light simulation or as a visual display in projects such as traffic management systems, intelligent transportation systems, or other projects where traffic light simulation is required. The module can be programmed to switch traffic lights according to a specific pattern or in response to specific inputs such as sensors or other signals. Some modules may also include additional features, such as built-in buttons or switches for manual control of traffic signal patterns or modes, or an infrared remote control for remote control. Some of the modules also have power supply and input voltage range protection. The LED traffic light compatible with Arduino consists of three 5mm LEDs in the colors red, yellow and green. Interface: common cathode, separate connectors for all three LEDs. Platform: For Arduino, Raspberry Pi or any other microcontroller. 220/330 Ohm resistors are needed for each pin where an LED is connected.

Use manual 1. Only can be officed by controller. 2. Input high or low level from the controller to make the LEDs ON or OFF. 3. It can also be

VooGenzek 6PCS Mini Traffic Light LED Display Module, DC 5V 5mm RGB Traffic Signal Light Electronic Module with Common Cathode Interface for Traffic

Let's Workshop: Traffic Light Module – Flux Workshop

Traffic Light Module — SunFounder Ultimate Sensor Kit documentation

LED Traffic Lights - Five Pack — PMD Way

Keyestudio Traffic Light Module (Black and Eco-friendly) For arduino

Adeept 5PCS Mini Traffic Light LED DC 5V 5mm Display Module for Arduino Creative DIY Project Kit, Raspberry Pi, Traffic Light for Traffic System Model : Electronics